All switches are electronic. The motor can be controlled either with sine or block commutation. Adjustable braking operation with feedback is possible. Special requirements can be realized by arrangement. Depending on the software version, various parameters can be set with an adapter cable without additional Software can be programmed or software updates installed.

Standard features:

• Measurement of operating current (both directions), motor voltage and operating voltage
• electronic on switch, switch for the power section can be controlled separately
• Reverse polarity protection, voltage proof up to 80V (optional 100V) maximum current 25A
• Control inputs 2x analogue voltage (1-4V standard, 0-10V possible) 3 switching inputs, 1 OC output
• serial interface (if supported by the program)
• alphanumeric LCD display or LED display via serial port
• Maximum current limit (15 other values can be set)
• The energy generated during dynamo and braking operation is fed back into the battery
• Connectable charging socket with switching input to switch off the engine during charging
• Programming via a serial interface [ using additional adapter cable and software ]or SPI with special programming device.

Dimensions: 100x80x25 mm, the circuit board must be placed on a sufficiently large heat sink or a heat sink must be mounted so that the power transistors are sufficiently cooled.

Contact us